The cleaning of hose type filter bags is carried out
By air at 0.5 bars, which is free of oil and water
The consumption of the cleaning air is found by this formula:
30 - 40 NLt (Newton liter) x bag x blow
Suitable to separate dust and other particles suspended in air of cleaning department aspirator system before being discharged to the outside with a bottom scraper.
The size of particles, paint pigments, pneumatic system of the mill, cleaning, aspiration
Physical composition of dust
Dust concentration in the untreated air (aspiration)
The given filter dimensions are taken into consideration in accordance with a 2.4 meter long bag.
The rate of flow changes depending on the rate of filtration area for other length of filter bags.
The air needed for cleaning and pneumatic control purposes of the Jet Plus Filter is supplied by a blower, which produces dry air
The air needed for cleaning and pneumatic control is obtained directly through a connection between the filter and the blower without using an air tank
The Jet Plus Filter is combined with a pneumatic control unit, which is actuated by an electronic control unit, quick ventilation valves (nozzles) and venture pipes
N1 Filtration phases in the N1 bag: The dusty air is purified (filtrated) in the outer surface of the hose type filter bag. N2 Final cleaning phase in the N2 bag: Dust loaded outer surface of the filter bags is cleaned respectively by blowing air from inside of bags. The accumulated dust is discharged out of the air lock due a scraper.
Features & Advantages
The filter can be used in the pressurized and vacuum systems. The cleaning of hose type filter bags is carried out by air at 0.5 bars, which is free of oil and water
The consumption of the cleaning air is found by this formula: 30 - 40 NLt (Newton liter) x bag x blow
The optimal flow geometry of the cleaning air route shows as mentioned below:
The loading capacity of filter for each product
The max cleaning capacity for each filter bag
The highest cleaning ratio of cleaned air
The filter body is combined with cleaning air tank
Therefore, there is no need for an additional air tank
The important criterions of filter loads
In addition to the given effective values at right, the loading of filter depends on some other factors such as, chemical reactions, drying, filtration process, etc. As an example, at wheat cleaning process, in a filter with a 2.4-meter long bag, maximum loading for aspirator would be 9 cubic meters per minute per square meter.
Fabricated cylindrical sheet-metal structure with tangential inlet and wide inspection doors Filtering sleeves supported by metallic circular cages with quick release clamps Pneumatic low pressure sleeve cleaning system utilizes compressed air at 0,6 bar Distribution group with solenoid valve to control rinsing valves Electronic equipment to position rotary manifold and program operation setting (rinsing time, pause, etc) Flat bottom with scraper
At food industry Flour and semolina mills Feed mills Biscuit and macaroni factories Nut processing plants Brewery factories Other food processing plants At chemical industry Paint factories Plastic factories Detergent factories At wooden industry At non-metallic industries At stone and soil quarries At cement factories For general use
Message was sent
Message was sent, soon our adviser will contact you…