Pushing panel for sheep pens BLASAU

This machine is used to push sheep along the corral from the feeding area to the restrainer.

Made of:

• 1400mm high panel with supporting frame, which moves horizontally and vertically.
• Passageway with two side latches 1500 mm high, sheet metal panel.
• Sheet metal entry doors, which open on either side, so that the animals to fill the passageway where pushing panel is (number of doors depends on the facility).
• Doors for staff to enter the restrainer area (number of doors depends on the facility).
• Two IPN rails in the passageway, placed at 2100 mm from the floor, with a toothed rack for the panel to move along.
• Carts that drag the panel and run along the rack, driven by a gear motor (power depending on the facility).
• Pneumatic system to raise up the panel as it moves back.
• Upper rail for electrical and pneumatic cables.
• Control panel that controls any variations in speed.
• 2 panels of buttons with manual switches to raise, lower and stop the barrier, as well as to move it forwards and backwards.
• 2 limit switches to stop the panel along its horizontal axis.
• 2 limit switches to stop the panel along its vertical axis.
• 2 limit switches to balance the panel along its vertical axis.

Total measurements and length: depends on the facilities.